The Seneca Woodworking Imperial Thickness Set for the Festool Domino DF700 allows you to quickly and effortlessly adjust the Domino fence offset to center your mortise on a range of imperial material thicknesses from 1/2" to 1". The set consists of two components: an Imperial Thickness Gauge and a "Domi-Shim." The Imperial Thickness Gauge installs in less than a minute using a Torx T10 bit (not included), and is a direct replacement for the metric thickness gauge included with your Domino DF700. The Domi-Shim attaches to the DF700 Fence to enable centering on narrower material than was previously possible without a shim or spacer.
The Imperial Thickness Gauge is CNC machined from Delrin material and designed to center on 1/2", 5/8", 3/4", 7/8", and 1" nominal ply thicknesses.
The Domino DF700 fence has a lower travel limit that would normally prevent it from centering on 3/4" or smaller ply so a shim is required to enable centering on these thicknesses. This set includes the Seneca Woodworking Domi-Shim required to work properly. This Domi-Shim can be installed by itself (without the Imperial Thickness Gauge) and used to center on 1/2" nominal ply. This Domi-Shim is the same 1/2" shim we originally sold as part of our Domi-Shim set. If you already own the set of two Domi-Shims, and want to upgrade to the faster adjustment that this set provides, you can purchase the Imperial Thickness Gauge separately HERE
Instructions are available HERE